forum

I had the same problem with raspbian jessie. So i switched back tho wheezy and everything was ok.
I did this because i did a fresh install anyway...

If you think it fits better in this section feel free to move it.
[moderator action] move done, left shadow copy under RaZberry

Unfortunately no. But now i have more devices with direct association to the RaZberry and less packet losses.

Because its only allowed to upload 3 pictures here is the finished RaZberry "Walkie Talkie"

In the last months i had some connection issues due to the poor singnal strength of the pcb antenna. So i decided to upgrade the antenna. I read a bit about adding a lenghth of wire to improve the antenna but that was not what i was looking for. Also i tried this method but ist was not much better. ...

Immer mit der Ruhe. Meiner Einschätzung nach arbeiten derzeit einfach viel zu wenig Leute an der Sache und die Jungs sind etwas überfordert weil es noch so viele Baustellen gibt. Jetzt mehr Entwickler einzustellen oder mehr Druck zu machen beschleunigt die Sache aber auch nicht mehr (siehe Anti-Patt...

Hello,

is there a reason why the maximum temperature for an virtual thermostat is 40°C?
A chance to set higher temperatures would be great (eg for water heaters). Maybe it wold be good to define the maximum temperature while configuring the app.

Hello,

it would be great if you could also provide a short changelog for the Release candidate.

At the moment i use tools like Kdiff to see what has been changed, so i can decide if it makes sense to upgrade.

I have the problem with Popp Z-Weather and With the Fibaro Universal Binary Sensor. For the Binary Sensor it helped a bit to power off and reconnect. Now it is sending correct data in most cases (about 3 wrong temperature readings a day - it is reading temp ~every 5 minutes) In case of the Z-weather...

it seems to work again with v2.2.1-rc3