forum

May have answered my own question. Via the "_Expert commands option"

How do I change parameters such as:
1.power change in percent
2.Energy reporting threshold
3.Periodic power reporting
4.Periodic energy reporting

Via the UI?

Just to be clear - I managed to update to 7.38 but doesn't fix the Z-Wave chip firmware issue (SiLabs SDK)

My firmware is 7.36. The UI says "Your stick uses the latest firmware". You say "You need to upgrade your firmware to the latest" but it seems it already is ????

I spoke too soon. When operating any switch Node I get 3 x Not delivered + Removing jot due to too many retransmissions. Then "check if node has failed" + Node is operating. Restarting the service does not fix but power cycle does

v4.1.1 locked on me again after about 6 hours so rolled I back to the earlier beta which was faultless for me over several days

I installed the beta version and so far no reoccurrences of the problem.

Have you had any success in resolving it? As I see it there could be a somewhat faulty node but is should never cause the item to get stuck, after all that is what the timeout is there for.

I have upgraded my several years old Smart Home controller to the latest Pi4 + Z-Wave.Me RaZberry 7 Pro (with external Antenna) + latest firmware after experiencing some strange problems with jobs stuck in queue. To my surprise the problem persists. Everything runs OK for a couple of hours or so the...

My Z-Wave.me Pi with pigyback Z-Wave serial board has around 25 nodes and has been running quite well for several years aside from Pi SD card failures from time to time. Every now and again I may add another node but mostly things stay constant. Over the last several months, every week or two severa...