forum

Hello PoltoS, thank you very much for your answer. But unfortunately that doesn't seem to help either. I have now looked at the "Zipato RFID Keypad" plugin (index.js). If I understand it correctly, the new RFID tag should be added in the function "failureCodeObserver". For this, ...

Hello, I have been using a Zipato RFID Mini Keypad for many years with Zway. After a complete reinstallation of the system with new razberry controller (7 Pro), I can now correctly include the Zipato, but I am unable to add my RFID tags. I have the current zway version v4.0.1 in use and also the Zip...

I must have done 30-40 interview attempts before it finally worked. After I have now set the noise measurement to 300s, the interview now seems to work after about 2-3 attempts. No idea if this is because of that, or was just coincidence. Unfortunately, I still can not teach my RFID tag. In the mess...

Hi, after numerous attempts the interview has now run completely. However, when I now install the "Zipato RFID Keypad" plugin, I get an error when saving the settings ("Something went Wrong"). The log shows the following: [2022-06-23 06:27:43.915] [I] [core] Instantiating module ...

Hi micky1500,

I have performed your procedure several times. Unfortunately it does not work for me. It keeps stopping at 90% and UserCode is not complete.
Can maybe someone else a tip for me? Maybe there is a possibility to do the interview via the terminal?

Hello, I have completely redone my system (new Raspi, new OS, new Razberry 7 Pro controller). I have meanwhile also re-added all devices to the network. Only the last device (Zipato RFID Keypad) can not be fully included. It keeps stopping at 90% because the intveriew for the UserCode class is not w...

Thank you very much for your answer. I am now also evaluating the scenes. But I did not work with EasyScripting, but with the if-then module from Zway. With a double click I can now raise or lower all blinds again. The solution via associations I find in principle but still better, because here also...

Hello, I have installed in my house 12 Fibaro Roller Shutter 2 (FGRM-222). Unfortunately, one of the devices does not seem to work correctly now. I can move the roller shutter up, down and also to any position, but the roller shutter no longer reports its current status to ZWay. However, the control...

I have now found the error. To protect the SD card, I use Berryboot to boot from a USB hard drive. Obviously with Berryboot you have to adjust the config.txt file with the following values directly before the installation: [pi4] arm_boost=1 [all] dtoverlay=pi3-miniuart-bt After the subsequent Z-Way ...

Hello, I bought a new Razberry 7 Pro and connected it to a Raspberry Pi 4. I installed Bullseye completely fresh and then installed Z-Way using " wget -qO - https://storage.z-wave.me/RaspbianInstall | sudo bash". Unfortunately, however, the controller does not seem to be recognized, althou...