Search found 6 matches
- 12 Nov 2018 12:24
- Forum: Discussions in English
- Topic: ZME-UZB1
- Replies: 11
- Views: 15047
Re: ZME-UZB1
I've been able to include a new (out of the box) module. So I guess there is no issue with the UZB controller, but rather in excluding an old module belong to the previous network. I think this thread is no longer the place for that issue... If needed I'll open a new thread. Thanks PoltoS for your p...
- 11 Nov 2018 13:32
- Forum: Discussions in English
- Topic: ZME-UZB1
- Replies: 11
- Views: 15047
Re: ZME-UZB1
Thanks PoltoS for your prompt response. Yes, both my modules and devices are on the EU frequency. ok, didn't know the Z-Way with UZB requires license. So back to square one (as I wrote - I could see the UZB flashing blue when sending the inclusion command from Home Assistant), but no module was adde...
- 09 Nov 2018 20:11
- Forum: Discussions in English
- Topic: ZME-UZB1
- Replies: 11
- Views: 15047
Re: ZME-UZB1
Hi @PoltoS, I've decided to go ahead and try to use z-wave.me proprietary tools to analyze the issues, so it will be easier for you to understand what is going on and offer a solution, so: 1. I've installed the Z-Way SmartHome Raspberry image 2. Made sure the UZB loads correctly (/dev/ttyACM0) 3. On...
- 09 Nov 2018 10:37
- Forum: Discussions in English
- Topic: ZME-UZB1
- Replies: 11
- Views: 15047
Re: ZME-UZB1
Hi there, me again - after resetting the UZB, I now cannot include any of the modules I have. I already hard reset also one of the modules (FIBARO switch 213) to no avail. I can see the UZB enter the inclusion mode (blue light flashes frequently), then performing the inclusion process on the module ...
- 07 Nov 2018 12:03
- Forum: Discussions in English
- Topic: ZME-UZB1
- Replies: 11
- Views: 15047
Re: ZME-UZB1
Apparently, hass.io runs on Resin OS and does not recognize the sudo command (or something of that like, I'm noob with linux...)
anyway, I ran it using Hassbian version (Home Assistant version of Raspbian) and it worked as expected. Thank you very much.
anyway, I ran it using Hassbian version (Home Assistant version of Raspbian) and it worked as expected. Thank you very much.
- 05 Nov 2018 20:47
- Forum: Discussions in English
- Topic: ZME-UZB1
- Replies: 11
- Views: 15047
Re: ZME-UZB1
echo -ne "\x01\x04\x00\x42\x01\xB8" > /dev/ttyACM0 Hi, I know it's an old post but I'm with the same need - I want to hard reset my Z-Wave.Me ZME_UZB1 USB Stick which I have connected to a RPi3 that runs hass.io (Home Assistant OS). When using SSH and running the command above, there is n...