Search found 7 matches
- 30 Jun 2018 11:18
- Forum: Z-Uno
- Topic: Reference Page - ZUNO_SENSOR_MULTILEVEL() - Incorrect?
- Replies: 2
- Views: 3032
Reference Page - ZUNO_SENSOR_MULTILEVEL() - Incorrect?
In looking at the reference page for ZUNO_SENSOR_MULTILEVEL(), I'm wondering if the top section is wrong. It says the syntax is; ZUNO_SENSOR_MULTILEVEL(type, scale_size_precision, getter) but, ZUNO_SENSOR_MULTILEVEL is a macro that takes 5 parameters. The description also doesn't match as it suggest...
- 28 Jun 2018 22:43
- Forum: Z-Uno
- Topic: ZUNO_THERMOSTAT - Returning temperature
- Replies: 5
- Views: 5054
Re: ZUNO_THERMOSTAT - Returning temperature
i Just wanted to say, that after some research and coding I now understand the concept of a ZWAVE thermostat and what you were trying to explain. I didn't realise that a ZWAVE thermostat definition is all about the SetPoint and Mode. It makes sense as the other sensors could include temperature, hum...
- 25 Jun 2018 23:38
- Forum: Z-Uno
- Topic: ZUNO_THERMOSTAT - Returning temperature
- Replies: 5
- Views: 5054
Re: ZUNO_THERMOSTAT - Returning temperature
Not sure what you mean by "point", is that the SetPoint temperature? You say use; zunoSendReport(channel_number) to return the update point, but is that just an unsolicited SetPoint temperature again ? I want to be able to to communicate the room temperature to the controller when requeste...
- 24 Jun 2018 22:53
- Forum: Z-Uno
- Topic: ZUNO_THERMOSTAT - Returning temperature
- Replies: 5
- Views: 5054
ZUNO_THERMOSTAT - Returning temperature
I've got the latest 1.4 beta and set up my ZUNO as follows: ZUNO_THERMOSTAT(THERMOSTAT_FLAGS_OFF|THERMOSTAT_FLAGS_HEAT, THERMOSTAT_UNITS_CELSIUS, THERMOSTAT_RANGE_POS, 40, getterMode, setterMode, getterTemp, setterTemp) My Z-UNO is talking (SoftwareSerial at 4800baud) to a PRT-N Heatmiser RS485 Ther...
- 22 Jun 2018 16:01
- Forum: Z-Uno
- Topic: New 2.1.4 beta
- Replies: 49
- Views: 44327
- 21 Jun 2018 00:12
- Forum: Z-Uno
- Topic: Hydronic header control with Z-Uno
- Replies: 2
- Views: 3252
Re: Hydronic header control with Z-Uno
I’ve been through similar thought processes. I have underfloor water based heating system with an 8port manifold downstairs and a similar one upstairs. Each port is connected to the respective room’s thermostat through a wiring centre. When the room thermostat triggers it not only activates the valv...
- 19 Jun 2018 07:55
- Forum: Z-Uno
- Topic: Serial strange behaviour
- Replies: 26
- Views: 24173
Re: Serial strange behaviour
+1 for <9600 capability
I’m building a zwave gateway (for SmartThings) to my Heatmiser thermostats. These run on RS485 and are fixed at 4800baud (8N1). I’m ready to test when available.
Thx
I’m building a zwave gateway (for SmartThings) to my Heatmiser thermostats. These run on RS485 and are fixed at 4800baud (8N1). I’m ready to test when available.
Thx