forum

After I updated the board I was able to upload the new boot loader. Its works again...

Don't know why it stopped working since nothing changed.

My Z-Uno stopped working I only get the green led blinking and I can't flash or upload the boot loader. Resetting doesn't help (5s on RST then three times tap). Any advice? Is the module broken? Arduino: 1.8.5 (Mac OS X), Board: "Z-Wave>ME Z-Uno, Europe, Disabled, Enabled, Disabled, Disabled&qu...

Thanks for your insights. Despite the battery, do you think there is wear on the electronics of the mower or not? This was my main concern.

I want to have the Z-Uno outside. It is a long way to indoors. If possible I want to avoid to have an external antenna, because this is prone to fail in heavy weather. I will check if POM-C could be an option. If ist is too expensive to build the whole casing maybe it would help to have parts of it ...

I want to make a weather proof casing for the Z-Uno (wind sensor). Outer diameter of 60 mm, inner diameter 54 mm, height about 100 mm. The most solid version would be made out of metal (aluminium or stainless steel using a milling machine). However, I expect the signal to be blocked 100% in that cas...

Update: it works as soon as I put the stuff in loop and add delays. Seems like this is the only way of doing it.

However, I am a bit concerned about requesting the status every two seconds from the mower (service port). Is this concern making sense?

Good point I tested it and it works like you said. So what could be wrong with Serial, because it worked with AltSoftSerial: https://forum.z-wave.me/viewtopic.php?f=3427&t=25584 Also if I use the delay the response is always immediate, I figured out this is by design... Maybe the mower needs mor...

Something is still wrong. Here's the updated code which should work. However wether I connect the Autonomer or not I always get -1. Even if I set a delay between clearing and reading I get the value almost immediately. It looks like as if the Z-Uno just ignores the delay(5000) completely. Any help i...

It didn't work as expected. I can send commands which are executed but if I read the status I don't get anything. basically I get "-1".

Any ideas?

I confirm the port is correct. I uploaded the sketch once and after it close the port I uploaded it again >> Error.

Now it doesn't work until I unplug it once.