forum

The hardware watchdog timer that we can enable is not configurable, so only two commands will be available: Start and Kick. We will think about adding it to the 2.1.1. Current 2.1.0 is almost out in beta - may be it will solve your problem

The getter is called in two cases:

• when controller sends a Get to Z-Uno (solicited Report) and
  when zunoSendReport is called (unsolicited Report)

Please have a look on images on pages 18-19 (chapter Getter/Setter concept) on https://z-uno.z-wave.me/QSG/

Вам нужны HTTP Device или Code Device. Второй вариант - это чтоб system использовать и рулить минами. У обоих есть выбор типа устройтсва

log is needed. and better description of the problem. hard to say otherwise

Provide us the log - we will see. May be the device do not announce this CC, but then send us a command and we instanciate it - you will then see it till then next Z-Way restart

With Fibaro we have seen that devices is not excludable sometimes. Use reset aequence from the manual

- Please check that the frequency of your RaZberry is same as if the device.
- Make sure to activate learn mode on the device
- Try to exclude first

No, it appears when device supports it. Most devices do not have it supported

You can have up to 10 channels. Some produce one device, some (like Sensor Binary) two devices in the UI. Plus some are mapped to the root. In total it might result in more than 10 devices in the UI.

If you talk about the picture on http://z-uno.z-wave.me/z-wave/interoperability-with-z-wave-controllers/, note that not all of them are switches. Some are sensors. Actually I don't remember what sketch was loaded in Z-Uno exactly on that screenshot, but you can see few duplicate devices. I don't kno...