forum

https://github.com/openhab/org.openhab.binding.zwave/blob/main/doc/intermatic/ca3000_0_0.md Also found this: >I’m referring to the case where a device only supports low-power inclusion mode >(like the Intermatic CA600, CA3000, and CA5100 devices). >The devices can only be paired when the controller ...

Did you just try clicking the buttons 3 times in a second? Or some other click combinations?
Like other z-wave devices.

Oha, da hast Du Dir Mühe gegeben mit dem Post! Kurz und knapp, IoBroker ist bestimmt ein gutes System als "Hut" über den verschiedenen Systemen. OpenHab wäre auch ein Kandidat, denke da muss man mal eine Installation machen und dann schauen wie man mit dem jeweiligen System zurechtkommt. H...

6.51.06 Fibaro FIBARO Smoke Sensor 3.03 Notification Sensor

Little higher version, but with security.

Did you just restart the z-way server, sometimes it´s the easiest solution.

Great news.

Funny, Polto wrote you can restore it from backup, you wrote you have the backup files. So, sometimes its good to read and understand. I just want to give you an idea what to do...... If you read the forum or manual you will find the answer. But I understand its easier to ask and waste other peoples...

If they are faint, the firmware is not starting (very unlikely unless you also updated the chip firmware during this maintenance). If they are bright, this means memory fault. FLASH memory have to be replaced. Of course it will clear your installation, but you can restore it back from the backup, s...

Haha, funny. I can see the same. As it wasn´t scrambled with 3.1.4. and I didn´t change anything
I couldn´t notice it earlier.
But you are right Franz.
Doesn´t matter if I use the app or the webinterface.

HI, in general it has nothing to do with zwave, even there are existimg interfaces.
But, I want to say that I wouldn´t use zwave if I have a central point, where i can control all devices.
Then there is no need to use zwave from my point of view.