forum

Can anybody explane how i did get a result as this back?

{"result":false,"success":true}

I try:

$$.result === 'true' ? 'on' : 'off'

but this doesn't work. Any suggestions?

Sounds bad... I get today my new one and this carry a label with SW1.01 MAY2016... before i get a newer one from September 2016 but also SW1.01. I think this one will be running only a few month an then it will be die. But before the other one must die, too. In most cases this seems to be happen if ...

This is the second one... My firmware is 1.01. I have another one and the runs fine with 1.01. The i will contact amazon again... I must replace all in the past... I don't have a clue which one now is not well...

No one?

I have different LC13 from danfoss and they stop working one by one with Error E1 in display itself. Danfoss say: Communication Error. I can't reincluded and after reset there is no chance to include again as a new device. I get E1. Now my question, is that issue comes from Danfoss or is that an err...

In last days i have an issue with my multi sensor and version 2.2.5. Motion detect itself freeze from time to time seems to be 24-48h that this freeze happens. After this freeze its look like everything ok, but no setup data will be saved in device and motion will not be received. After restart of S...

First setting is to make wakeup shorter. Only for configuration set it to 60. Thereafter wake up your device with a SHORT push on the button inside. The data will be send to the device. You can monitor via: expert menu -> controller info -> view job queue There you can see all settings you set as da...

You can monitor the data via expert menu what does happening there?

If you are in range after set all options wake up of device is necessary! It's a battery device and battery device goes into deep sleep. Please read and search for battery device in zwave networks how they work. Set you options and then wake up your device with pushing the button mounted in device. ...

First try range check! The ball must be illuminate green. If not, you are out of the network. You must check different templates. There are some they have bugs. You must use some with less bugs. If you want to change some values, you must use expert ui... It's totally stupid and if you are fresh in ...