Hi
I keep trying to connect to your service to test it out but whenever i get to the 'loop' stage i receive an error saying "Sorry' server has not completely started yet...". And I keep getting ths whenever I try to connect, is there a stability issue on your side or mine?
I also get an Z-Connector - Socket has gone message too
ZCU-201 on Win 7 64bit using Chrome Browser.
So far I'm not having much success getting your solution to work.
Errors Errors Errors - Server & Socket issues
You certainly use wrong COM port
"Socket has gone message" after about 10 econds means that wrong port is used.
"Sorry' server has not completely started yet..." message means that Z-Cloud has not succeed in communications with your hardware (stick). This is also due to wrong port selected.
Please make sure you have a driver installed for ZCU-201 and correct port is used in Z-Connector.
I guess where you buy your ACT dongles! They are the worst on the market (they are based on a VERY old Z-Wave SDK)
"Sorry' server has not completely started yet..." message means that Z-Cloud has not succeed in communications with your hardware (stick). This is also due to wrong port selected.
Please make sure you have a driver installed for ZCU-201 and correct port is used in Z-Connector.
I guess where you buy your ACT dongles! They are the worst on the market (they are based on a VERY old Z-Wave SDK)