EZMotion, Trane thermostat devices

rhanson · Post by **rhanson** » 07 May 2013 00:12

I have set up Z-cloud correctly, and I can control my lights.

However, I have EZMotion devices that are not recognized. What device specification to use? I assume that the motion detector part will show up as a sensor? Is it also possible to get the light and temperature values as sensors, or only through scripting?

I also have two Trane z-wave thermostats that are connected (communicating with z-stick), but I cannot control them through z-cloud. How do I make them work?

Thanks

Post by **PoltoS** » 07 May 2013 00:12

EZMotion have a new version that does not work yet to show luminecence and temperature. But motion detection works.

Which thermostats are you using?