Hi All
I really need help. I've tried to get my 1st set up running with both Domoticz and Open Source Automation. I can't seem to get it right, but i think it boils down to the COM port config.
What I have done is downloaded OZWForm and after running I get the below message:
Dumping queued log messages
2014-07-14 15:42:59:571 7632 ERROR: Failed to open serial port \\.\COM1 (attempt 1)
2014-07-14 15:42:59:581 7632 WARNING: Failed to init the controller (attempt 8)
End of queued log message dump
2014-07-14 15:43:04:621 Opening controller \\.\COM1
2014-07-14 15:43:04:631 Trying to open serial port \\.\COM1 (Attempt 1)
2014-07-14 15:43:04:651 ERROR: Cannot open serial port \\.\COM1. Error code 2
Dumping queued log messages
2014-07-14 15:43:04:621 7632 Wait::Multiple res=-1 num=1 >
2014-07-14 15:43:04:621 7632 Opening controller \\.\COM1
2014-07-14 15:43:04:631 7632 Trying to open serial port \\.\COM1 (Attempt 1)
2014-07-14 15:43:04:651 7632 ERROR: Cannot open serial port \\.\COM1. Error code 2
End of queued log message dump
2014-07-14 15:43:04:711 ERROR: Failed to open serial port \\.\COM1 (attempt 1)
2014-07-14 15:43:04:721 WARNING: Failed to init the controller (attempt 9)
Dumping queued log messages
2014-07-14 15:43:04:711 7632 ERROR: Failed to open serial port \\.\COM1 (attempt 1)
2014-07-14 15:43:04:721 7632 WARNING: Failed to init the controller (attempt 9
The Nodes do not come up in OZWForm.
Please help