Unable to load Data
Posted: 10 Jun 2016 22:44
My UI is unable to "load data" (firmware: 2.2.2). The system ran quite well for about two months. Now each try to open the UI is answered by that message (:8083), access on port 8084 ois not possible due to webif problem.
I installed a brandnew system with "wget -q -O - http://razberry.z-wave.me/install | sudo bash" -> same error.
Factory default -> unable to retrun the system on factory default
How to reset the corrupted data base?
I installed a brandnew system with "wget -q -O - http://razberry.z-wave.me/install | sudo bash" -> same error.
Factory default -> unable to retrun the system on factory default
How to reset the corrupted data base?