Adding Razberry as secondary to Vera

[Mike Yeager]

Ok, I've been at this all day and tried every combination I can think of. How does one add the Razberry as a secondary controller to a Vera? I've tried the obvious controller change route and it's gone nowhere. The RPi is sitting about 2 feet from the Vera....

[PoltoS]

You need to press Start Learn Mode button on RaZberry. If it is disabled, you have to do Reset to Factory Default first. In Vera use Add device as usually.

[Mike Yeager]

Does this actually include it in the network? I was trying to use the "Start Controller Change" button as it states in the description that it does what I'm looking to do. Thanks for your reply and I look forward to further clarification.

[PoltoS]

Controller Change means that Z-Way/RaZberry will include another controller and transfer Primary Controller role to the newly included node

[Mike Yeager]

I would have thought that was what I was trying to do...

[PoltoS]

If you want to make Vera Primary/SIS, you need to use this button on RaZberry and LearnMode on Vera. But I don't know where is LearnMode button in Vera