Here is my problem. I have a Fibaro double switch controlling two lights. The device presents itself with three instance 10.0, 10.1, 10.2. One light responds to both 10.0 and 10.1. Thus, when I use the web interface everything works, but when I switch the light manually, the interface does not update itself and the system does not know that the light it's on or off. Because I use MQTT, it is crucial for me that the interface gets the switch change right away.
Any help?
thanks, marcello
Smart home interface update
Re: Smart home interface update
Did you make an association to the controller lijke this one?mcfanda wrote:Thus, when I use the web interface everything works, but when I switch the light manually, the interface does not update itself and the system does not know that the light it's on or off.
Re: Smart home interface update
Hi
I have it like this, which is the same for other devices that works fine. I've tried to modify it, but without joy
I have it like this, which is the same for other devices that works fine. I've tried to modify it, but without joy
Re: Smart home interface update
- You did remove the existing associations, and tried to add new ones?I've tried to modify it, but without joy
- Which Zway version do you have?
Re: Smart home interface update
HI
(sorry for the delay). Yes, I've tried with no joy. I've also noticed that all my devices are associated with Z-Way controller in the same way (with the little red triangle).
I have a Z-Way chip ZW0500, firmware 6.51.03, software version v2.2.3
(sorry for the delay). Yes, I've tried with no joy. I've also noticed that all my devices are associated with Z-Way controller in the same way (with the little red triangle).
I have a Z-Way chip ZW0500, firmware 6.51.03, software version v2.2.3
Re: Smart home interface update
Hi there,
I have a similar issue - My workaround is to use the "Periodical Switch Polling" app, which polls my switches every minute to update the current states.
I am using a AUS Digital Home Systems In wall Dual Switch in my case and have a similar set of switches (Switch 1.0, 1.1, 1.2) One is a switch all, and then 2 individuals.
For me, Polling every minute works for me, but I can see what you mean if you want the switch to trigger other events...
Tim
I have a similar issue - My workaround is to use the "Periodical Switch Polling" app, which polls my switches every minute to update the current states.
I am using a AUS Digital Home Systems In wall Dual Switch in my case and have a similar set of switches (Switch 1.0, 1.1, 1.2) One is a switch all, and then 2 individuals.
For me, Polling every minute works for me, but I can see what you mean if you want the switch to trigger other events...
Tim
Re: Smart home interface update
thanks T. I'll try the polling option
Re: Smart home interface update
Thanks man this works me
Removing the existing associations, and tried to add new ones?