How to set a sensor value to a multilevel switch

Discussions about Z-Way software and Z-Wave technology in general
Post Reply
roger
Posts: 10
Joined: 29 Jun 2017 23:28

How to set a sensor value to a multilevel switch

Post by roger »

I want to set the speed of a fan with a multilevel dimmer device, and the speed should depend on the values of some sensors.

I use some calculated sensors (for example from the app mathematica) as variables in the calculation, but then I want to set the calculated value to the fan device with a defined interval.
What I need is anything like "if sensor A is > sensor B then set multilevel switch to value of sensor C".
I think that this is a very basic use of an automation system, but all apps that I have found seemed to could only set a multilevel switch to a not dynamical integer value.

Anyone who know a way to do anything like this?
Post Reply