http access via web browser and OpenRemote
Posted: 03 Oct 2017 16:27
I am quite new of the system I installed on a pi the software v2.3.4; then I installed a few devices (temperature sensors, switches, etc)
and configured rooms.
All works fine, but, I have some trouble when I try to access via http to devices. I created a virtual thermostat and
my understanding was that by accessing the URL
http://IP:8083/OpenRemote/ThermostatLev ... tDevice_40
where ThermostatDevice_40 is the device ID I should be able to read the temperature, but in firefox nothing show up
If I do
wget http://IP:8083/OpenRemote/ThermostatLev ... tDevice_40
the results is a 404 Not Found; chrome also give page not found.
My goal is actually to both read and set temperature levels programmatically so that I can change the temperature level during the day.
Did I wrongly interpreted the documentation of the OpenRemote app? Is there something wrong I am doing?
Did I miss some details?
Any help will be appreciated.
and configured rooms.
All works fine, but, I have some trouble when I try to access via http to devices. I created a virtual thermostat and
my understanding was that by accessing the URL
http://IP:8083/OpenRemote/ThermostatLev ... tDevice_40
where ThermostatDevice_40 is the device ID I should be able to read the temperature, but in firefox nothing show up
If I do
wget http://IP:8083/OpenRemote/ThermostatLev ... tDevice_40
the results is a 404 Not Found; chrome also give page not found.
My goal is actually to both read and set temperature levels programmatically so that I can change the temperature level during the day.
Did I wrongly interpreted the documentation of the OpenRemote app? Is there something wrong I am doing?
Did I miss some details?
Any help will be appreciated.