Netatmo wrong vdev icons

Discussions about Z-Way software and Z-Wave technology in general
Post Reply
Provo
Posts: 112
Joined: 19 Oct 2016 19:54

Netatmo wrong vdev icons

Post by Provo » 14 Dec 2017 08:40

Since the Netatmo app doesn't seem to be on github, I can't really raise an issue or provide a pull request, so I have to complain a bit to the developers here instead.

The Netatmo app uses a couple of slightly off icons for its devices. Specifically the CO2 sensor uses 'co' but should have used 'coo'; the barometer uses 'multilevel' but should have used 'barometer; and the noise meter uses 'multilevel' while it arguably should have used 'meter' (as a half lit light bulb makes little sense in that context).

From inspecting the code, I also see that the rain devices use 'humidity' while they should have used 'rain'; and the wind devices all use 'multilevel', while they should have used 'meter'.

It would be nice if you could fix this or publish the code on github so you could accept PRs for it.

User avatar
PoltoS
Posts: 4251
Joined: 26 Jan 2011 19:36

Re: Netatmo wrong vdev icons

Post by PoltoS » 17 Dec 2017 23:48

If you can fix it, please put it in your git and then make commits with the fix - we can then pull that to our git.

From my side I'll attract developers attention to that module.

Post Reply