I have setup a very simple Gateway using a RaspberryPi running Hassio and have a Aeoteck Z-Stick Gen5.
I am now looking to implement my own devices on the Z-Wave network.
I would like to create a device that is measuring device with a piezo sounder. When a measured parameter exceeds a predetermined level, it will beep an alarm. It will send out a message that will cause remote devices to beep an alarm.
I have read something that states that a Z-Wave device can be either a Sensor or an Actuator - I think my requirements mean I need my device to be both Actuator and Sensor - Is this possible?
Thank in advance.
Discussions about Z-Way software and Z-Wave technology in general
2 posts • Page 1 of 1
No, it can be both. I.e. multisensors or Qubino devices, which have both switch and sensors. If you're looking to make your own custom device, then it worth to have a look on Z-Uno device, it can be programmed your own way. And there are plenty of examples on developers page.