aeotec multisensor 6 - device configuration missing

Discussions about Z-Way software and Z-Wave technology in general
Post Reply
dirkh
Posts: 10
Joined: 19 Dec 2016 19:24

aeotec multisensor 6 - device configuration missing

Post by dirkh » 23 Nov 2018 10:32

I have several Aeotec Multisensor 6 EU, which acctually works fine.

Unfortunately, since zway 2.38 the device configuration page has been changed for several devices.

If I set the device description ("Select Device Description"), the dedicated settings were shown for the MultiSensor.
In example, "Nº 4 - Enable/disable the function of motion sensor." or "Nº 5 - Motion Detection" with all possible values.

If I change (or select) the device description in the new version, there is only "Wakeup time, seconds ... " remaining.
All other possible settigns vanished.

Also I noticed that device "FGRM-222" (Fibaro Roller Shutter) is not in the list anymore

Any Idea/Solution ??? Or is this just new feature.

Dirk

User avatar
PoltoS
Posts: 4334
Joined: 26 Jan 2011 19:36

Re: aeotec multisensor 6 - device configuration missing

Post by PoltoS » 04 Dec 2018 00:31

We are now taking the database from the Alliance. You can take the zddx you need from the old distro and run UpdateXMLs.py in the folder

Post Reply