RC31 Device Config in new UI goes wrong

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
hpd
Posts: 34
Joined: 20 Mar 2014 12:03

RC31 Device Config in new UI goes wrong

Post by hpd » 08 Dec 2014 23:17

I have considerable problems configuring my vraious Switches (Fibaro). But I think it is not device specific.

I have different behaviours which I can not reproduce properly:

1. if I press enter after having changed a parameter the value turns back to the original value - but just for a short while and turns back to the edited value. This is just puzzling the user, but I can live with that.

2. if I press enter after having changed a parameter the value turns back to the original value. The value will not change. This can be repeated until for whatever reason, sometimes it goes back to nr. 1

I use old and new ui in parallel (not concurrent) because of this misbehaviour. Not sure wether I make things worse by doing so. But in old ui I have less problems.

Bye the way. I know you want to drop old ui. But it would be helpfull if renaming device would do this for old ui as well.
Z-Way 2.0.0-final on Raspberry Pi

Post Reply