I have considerable problems configuring my vraious Switches (Fibaro). But I think it is not device specific.
I have different behaviours which I can not reproduce properly:
1. if I press enter after having changed a parameter the value turns back to the original value - but just for a short while and turns back to the edited value. This is just puzzling the user, but I can live with that.
2. if I press enter after having changed a parameter the value turns back to the original value. The value will not change. This can be repeated until for whatever reason, sometimes it goes back to nr. 1
I use old and new ui in parallel (not concurrent) because of this misbehaviour. Not sure wether I make things worse by doing so. But in old ui I have less problems.
Bye the way. I know you want to drop old ui. But it would be helpfull if renaming device would do this for old ui as well.
RC31 Device Config in new UI goes wrong
RC31 Device Config in new UI goes wrong
Z-Way 2.0.0-final on Raspberry Pi