RC31 Device Config in new UI goes wrong
Posted: 08 Dec 2014 23:17
I have considerable problems configuring my vraious Switches (Fibaro). But I think it is not device specific.
I have different behaviours which I can not reproduce properly:
1. if I press enter after having changed a parameter the value turns back to the original value - but just for a short while and turns back to the edited value. This is just puzzling the user, but I can live with that.
2. if I press enter after having changed a parameter the value turns back to the original value. The value will not change. This can be repeated until for whatever reason, sometimes it goes back to nr. 1
I use old and new ui in parallel (not concurrent) because of this misbehaviour. Not sure wether I make things worse by doing so. But in old ui I have less problems.
Bye the way. I know you want to drop old ui. But it would be helpfull if renaming device would do this for old ui as well.
I have different behaviours which I can not reproduce properly:
1. if I press enter after having changed a parameter the value turns back to the original value - but just for a short while and turns back to the edited value. This is just puzzling the user, but I can live with that.
2. if I press enter after having changed a parameter the value turns back to the original value. The value will not change. This can be repeated until for whatever reason, sometimes it goes back to nr. 1
I use old and new ui in parallel (not concurrent) because of this misbehaviour. Not sure wether I make things worse by doing so. But in old ui I have less problems.
Bye the way. I know you want to drop old ui. But it would be helpfull if renaming device would do this for old ui as well.