Error handling data from blah.Set(blah)

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
Mirar
Posts: 113
Joined: 19 Oct 2014 16:54
Location: Stockholm

Error handling data from blah.Set(blah)

Post by Mirar »

When setting a parameter in the Expert UI, sometimes the response is:
"Error handling data from blah.Set(blah)"
This seems to be because

Code: Select all

[2015-02-02 09:09:39.979] [C] [zway] Node 18:0 CC Configuration: No value size for parameter 0x03
Maybe this could be translated into a useful error message in the UI?

Also I don't know why it doesn't know the size of this, it's a normal configuration parameter. I used the expert UI since all the values in the Configuration tab was wrong (again).
Top
Post Reply

Return to “RaZberry”