Set Parameters from device
Posted: 03 Jul 2016 15:39
Hello together,
i use a Fibaro Motion Sensor with 2.7 Firmware. The manual say that define parameters are available:
http://manuals.fibaro.com/motion-sensor/
My goal is to increase the illuminating sensor with sending data. Default is 0 no sending data. Thats bad.
I found a link in web that makes Temp more times:
wget http://192.168.10.xxx:8083/ZWaveAPI/Run ... (64,600,2)
So i dont know what this parameters mean!
How can i set parameters for illumination as fibaro say in manual?
i use a Fibaro Motion Sensor with 2.7 Firmware. The manual say that define parameters are available:
http://manuals.fibaro.com/motion-sensor/
My goal is to increase the illuminating sensor with sending data. Default is 0 no sending data. Thats bad.
I found a link in web that makes Temp more times:
wget http://192.168.10.xxx:8083/ZWaveAPI/Run ... (64,600,2)
So i dont know what this parameters mean!
How can i set parameters for illumination as fibaro say in manual?