Check if razberry is working

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
Helleman
Posts: 38
Joined: 25 Dec 2016 14:04

Check if razberry is working

Post by Helleman »

Hello

I am new here and I am a totally newbie at Raspberry, Linux and Razberry.
I am trying to install a Razberry to work together with Domoticz. I seem to have been able to install everything according to the guides I have used but I cannot get Domoticz to add a Z-wave smart energy plug. Since I am just following guides it is problematic for me if something goes wrong sonce I would not detect it nor could I try and improvise... :D

So to my question; How can I check if my Razberry is working properly with drivers and everything? Can I ping the Razberry unit just to se if it is alive? I have read that some people checks loggs, but where are they stored?
I have googled and searched several forums whithout any luck since my search string becomes to common...
pasi
Posts: 2
Joined: 23 Dec 2016 11:49

Re: Check if razberry is working

Post by pasi »

First it would be good to check that razberry and the sensor use same frequency. EU and USA models use different frequencies and won't work together.
Helleman
Posts: 38
Joined: 25 Dec 2016 14:04

Re: Check if razberry is working

Post by Helleman »

Both Razberry and sensors are bought in the same store in Sweden, so they should use the same frequency, but how do I check this?
Post Reply