Page 1 of 1

MultiChannel association problem

Posted: 06 Apr 2017 12:10
by e-rook
Hello

I am using most recent Z-wave.me software and I have problem with MultiChannel - either I do not understand or I have issue:

I have:
* two channel wall switch TKB Home TZ37 with Command Classes interviewed - Basic • SwitchBinary • SwitchAll • SceneActivation • SceneActuatorConf • AssociationGroupInformation • DeviceResetLocally • ZWavePlusInfo • MultiChannel • Configuration • ManufacturerSpecific • PowerLevel • FirmwareUpdate • Association • Version • SwitchBinary • SwitchBinary •
* Philio switch 2x1.5kW PAN04 with CC - Basic • SwitchBinary • SwitchAll • SceneActivation • SceneActuatorConf • Meter • AssociationGroupInformation • DeviceResetLocally • ZWavePlusInfo • MultiChannel • Configuration • Alarm • ManufacturerSpecific • PowerLevel • Protection • FirmwareUpdate • Association • Version • Basic • SwitchBinary • Meter • Basic • SwitchBinary • Meter • Basic • SwitchBinary • Meter •

I would like to create association which:
* left double-click on TZ37 turns on/off PAN04 channel 1
* right double-click on TZ37 turns on/off PAN04 channel 2

So far I can only associate that double click turns PAN04 globally - meaning both channels.

When checking Expert Commands I have empty MultiChannel section and in Association I cannot choose separate channels. Can you advice me if my thinking is correct and I should be able to have such kind of switching - and if so - how to achieve it?

Cheers,
Piotr "Rook"

Re: MultiChannel association problem

Posted: 10 Apr 2017 11:30
by e-rook
Can anybody confirm if at least my MultiChannel understanding is correct?

Re: MultiChannel association problem

Posted: 16 Jun 2017 02:49
by PoltoS
You are looking for MultiChannelAssociations.

MultiChannel should be supported in target device