Zway Exclusion works - Inclusion not

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
Posts: 2
Joined: 29 Apr 2017 11:42

Zway Exclusion works - Inclusion not

Post by Sidekickat » 29 Apr 2017 12:01

Hi there! I am new to the Raspberry/Razberry/Z-Wave world and it's driving me nuts :?

I use a Raspberry PI 3 B with Razberry2 ZMEERAZ2 and installed Z-Way on Raspian. In Z-Way I want to add a Fibaro Roller Shutter 2 FGR-222 (EU). I start the exclusion and push the B-Button on the Fibaro 3 times very fast and Z-Way shows me a success message. After that I start the inclusion and hit the B-Button 3 times very fast again but the inclusion runs in a timeout ('inclusion takes a long time to start up').

I did a factory reset on the Fibaro and tried a second Fibaro Roller Shutter 2 but it ended up with the same behaviour.
Then I installed Z-Way again (this time I used the SD-card image) and again: The exclusion works but the inclusion not.

Is it likely that I have a bad Razberry-Module and a replacement unit should work?
Thanks for any suggestion before I have to send the device back!

User avatar
Posts: 3739
Joined: 26 Jan 2011 19:36

Re: Zway Exclusion works - Inclusion not

Post by PoltoS » 30 May 2017 20:15

Inclusion log is required.

If inclusion doesn't work, but exclusion do, means you don't initiate inclusion on the device (wakeup sequence is used) or RaZberry is not primary

Post Reply

Who is online

Users browsing this forum: Bing [Bot] and 3 guests