My Pi died on me, so I reinstalled it and after the installation I first went to http://localhost:8084, which showed me the Firmware Update page.
I then went to http://localhost:8083 and tried to login....
The RaZberry no longer accept my password??
I can't for the life of me remember what email address i have used with it, so i can't try to reset the password :-\
How can I reset the RaZberry to factory settings?
(I don't have that many z-wave devices, so loosing the config is no issue)
Reinstalled Pi, can't login to Z-Wave Smart Home
Re: Reinstalled Pi, can't login to Z-Wave Smart Home
After skiming through the developer pdf I think it's possible by using "SetDefault()", BUT... how do I go about doing that?
Anyone that could do me the favor of creating a small package I could run on my Pi?
(Runing it from the browser ( http://localhost:8083/ZWaveAPI/Run/cont ... SetDefault() ) , only results in "Not logged in)
Anyone that could do me the favor of creating a small package I could run on my Pi?
(Runing it from the browser ( http://localhost:8083/ZWaveAPI/Run/cont ... SetDefault() ) , only results in "Not logged in)
Re: Reinstalled Pi, can't login to Z-Wave Smart Home
Well... something funky is going on...
I decided to downgrade to 2.0.1 which I knew were installed on the old pi installation (had installed 2.3.4 when I reinstalled the pi)
After the downgrade the RaZberry accepts my old password again???
So this issue is solved (sort of)
I decided to downgrade to 2.0.1 which I knew were installed on the old pi installation (had installed 2.3.4 when I reinstalled the pi)
After the downgrade the RaZberry accepts my old password again???
So this issue is solved (sort of)