Hi, I have a few Fibaro FGK-101 door/window sensors, which used to work fine.
Haven't used them for a while and tried to include them in a network without
any success. I did reset the sensors according to manual. I'm using zway v2.3.6
with a razberry (ZW0301).
When I try to include them the blue starts blinking and it appears the razberry
never received anything. The UI times out after a while and the zway.log shows
not a trace of the sensor or any failures.
Any idea what I could try to make them work again?
Discussions about RaZberry - Z-Wave board for Raspberry computer
1 post • Page 1 of 1