Page 2 of 3

Re: Interview incomplete - Fibaro Universal Sensor FGBS-001

Posted: 20 Jan 2019 18:55
by Spirit78
Hom is it done?

I try the link with my ip-adress but it doesn´t work. I guess I must type in the sensor number somewhere? But how?
I would like to try bruteforce too, though the interview stucks at 86%

Re: Interview incomplete - Fibaro Universal Sensor FGBS-001

Posted: 21 Jan 2019 14:00
by enbemokel
ip:8083/JS/Run/zway.devices"NNN".instances"III".AlarmSensor.data.interviewDone

Hi, yes, you should exchange the IP address in the biginning, with your real Ip address.
NNN must be exhaged with your device ID an the instance you have to try from 1 to 4. This worked for me.

Re: Interview incomplete - Fibaro Universal Sensor FGBS-001

Posted: 22 Jan 2019 01:23
by Spirit78
Thanks! I will try tomorrow.

NNN, is it #14 for example? And its just to try I, II, III and IIII?

Re: Interview incomplete - Fibaro Universal Sensor FGBS-001

Posted: 22 Jan 2019 16:51
by enbemokel
Yes, NNN is 14 for example, I´m not sure if i try instances with 1 2 3 4 or I II III IV or IIII

But you will see it in the browser.

Also, the link was incomplete, you have to type in at the end = true
ip:8083/JS/Run/zway.devices"NNN".instances"III".AlarmSensor.data.interviewDone = true

Re: Interview incomplete - Fibaro Universal Sensor FGBS-001

Posted: 24 Jan 2019 23:47
by Spirit78
Thank´s Now finally it worked for me too :)

Re: Interview incomplete - Fibaro Universal Sensor FGBS-001

Posted: 27 Jan 2019 01:10
by Spirit78
Thats what I thougt too at last. But mine were working in previous versions so it got a little strange. But the link did it for me👍

Re: Interview incomplete - Fibaro Universal Sensor FGBS-001

Posted: 14 Feb 2019 17:23
by Willem_K
I tried the link above (double checked it) but I get "SyntaxError: Unexpected string".

http://192.168.1.200:8083/JS/Run/zway.d ... wDone=true

What am I doing wrong?

Re: Interview incomplete - Fibaro Universal Sensor FGBS-001

Posted: 14 Feb 2019 17:44
by enbemokel
http://ip:8083/JS/Run/zway.devices[NNN] ... wDone=true

I think because i changed the [ with " to explain it.

Re: Interview incomplete - Fibaro Universal Sensor FGBS-001

Posted: 14 Feb 2019 20:28
by Willem_K
Aha, that was the trick. That worked. The tab "configuration" however doesn't get populated unfortunately. It says "This device doesn't have the necessary service".

Re: Interview incomplete - Fibaro Universal Sensor FGBS-001

Posted: 15 Feb 2019 12:54
by enbemokel
Yes, you may configure it with the Expert Commands menu