Kwikset - any way to swap ON/OFF ?

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
Pabluski
Posts: 1
Joined: 24 Apr 2018 04:53

Kwikset - any way to swap ON/OFF ?

Post by Pabluski » 03 May 2018 19:30

I have a Kwikset 910 that I added a zwave card to. It reports "ON" when it is unlocked, and "OFF" when it is locked. It seems that this causes confusion with the Opehhab2 controller and with Alexa. I have created a virtual device in Openhab and set up rules to update it accordingly. This has not been a satisfactory solution. Is there a way to change the output of the device in the Z-Way software?

Thanks!

Post Reply