Configure the FIBARO RGBW Controller

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
billyboy
Posts: 57
Joined: 16 Mar 2013 21:33

Configure the FIBARO RGBW Controller

Post by billyboy » 05 Jul 2018 20:03

The FIBARO RGBW Controller has 2 operation modes, RGBW mode to control ed. LED strips and a input/output mode.
Default it's in RGBW mode. When I include this device to the network it's a RGBW device but I need it in input/output mode. Therefor I need to configure parameter 14 to 34952. I can do this in the configuration tab of this device. But the device mode is not changed. Not after power cycle or a re-interview. When I exclude and re-include the device, it's back into the default mode.

Does someone know how to do this?

Post Reply