Login error
Posted: 19 Aug 2018 17:49
First of all, hello. Im new to this forum.
I currently use Tellnet znet to control lamps in my house. Now I wanted to connect Aeon sensor 6 (humidity, temperature, light and motion detection) and also couple this to a siren so when someone is in my garage the siren sounds when activated. I have some knowledge of linux but it was Hundreds of years since I used it...
My hardware is this:
Raspberry pi 3 B+
Razberry v2 gen5
Ethernet cable connected
Logitech illuminated keyboard connected (when connected I get warning low voltage?)
Sandisk Ultra SDHC 16GB
I have tryed both dometics and openhab and this one (raspbian and z-way). I have tested raspbian jessie from 2017 and several stretch and stretch lite versions and ofc the clean ready made "razberry-2.2.5-wifi_public.img" and burnt it with etcher to my SDHC. I have started SSH, timezone and so on... When I surf to find.zwave.me I see the login page and also I see an IP below stating (in my case) 192.158.1.72. When clicking this (ofc with port 8083) I just get connection refused from my desktop. I have tested both my pi login name "pi", standard admin and so on. Very little information about what standard login name should be. Am I forced to use the raspbian desktop version and locally try the webpage with admin:(empty psw) ?
Best regards, optiix.
I currently use Tellnet znet to control lamps in my house. Now I wanted to connect Aeon sensor 6 (humidity, temperature, light and motion detection) and also couple this to a siren so when someone is in my garage the siren sounds when activated. I have some knowledge of linux but it was Hundreds of years since I used it...
My hardware is this:
Raspberry pi 3 B+
Razberry v2 gen5
Ethernet cable connected
Logitech illuminated keyboard connected (when connected I get warning low voltage?)
Sandisk Ultra SDHC 16GB
I have tryed both dometics and openhab and this one (raspbian and z-way). I have tested raspbian jessie from 2017 and several stretch and stretch lite versions and ofc the clean ready made "razberry-2.2.5-wifi_public.img" and burnt it with etcher to my SDHC. I have started SSH, timezone and so on... When I surf to find.zwave.me I see the login page and also I see an IP below stating (in my case) 192.158.1.72. When clicking this (ofc with port 8083) I just get connection refused from my desktop. I have tested both my pi login name "pi", standard admin and so on. Very little information about what standard login name should be. Am I forced to use the raspbian desktop version and locally try the webpage with admin:(empty psw) ?
Best regards, optiix.