Page 1 of 1

UZB1 TransmitQueue overflow

Posted: 30 May 2019 19:47
by RobertHerter
Hello,

I habe an UZB1 with newest firmware that makes Problems in including new devices.
On fhem and openhab I get instantly the error that the transmit queue is full.
Contacted both developer and both stated a messed up Stick.
Tried to downgrade firmware and reupgrade but both results in the same behaviour.

Is this a know Problem and is there any fix without hard reset and learn 80+ devices new.

Regards

Robert

Re: UZB1 TransmitQueue overflow

Posted: 07 Jun 2019 16:15
by PoltoS
We do not know about such a problem. You might want to make a backup and restore it back after full reset