Strange issue with Libre Impress on loop

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
mukeshkabra
Posts: 1
Joined: 19 Sep 2019 09:50

Strange issue with Libre Impress on loop

Post by mukeshkabra » 19 Sep 2019 09:51

So I am trying to do some digital signage and I have all the images and information loaded into a Libre Impress slide show. Nothing fancy just images and no transition animations.

When the Pi 2 boots it starts Libre Impress and the show gets underway. It will loop and loop for about 40-50mins, then it just stops. It isn't frozen can move the mouse hit escape and it will close the slide show to a desktop. If I relaunch the application it will go back to looping again for another 40-50mins then stop again.

I have checked the logs /syslog and /messages nothing there. I have adjusted the system to have 256mb of ram for the UI just on the off chance there was something there. I am kind of at a loss. I know there are many other applications out there I am just looking for simple offline solution.

Post Reply