I have a set of StellaZ thermostats,controlling them with a Zipabox. I have some problems. I’m no Z-wave expert.
I need to change the operation mode one the StellaZ to direkt valve control, so the Zipabox can use an external thermometer and control the valve to maintain set temperature with the external sensor as referens.
The StellaZ manual just list the commands that need to be sent to put it in direct valve control mode, but I have no ide how to send them. The commands I need to send is:
BASIC SET 0xfe, THERMOSTAT MODE SET 0x1f
I have no ide how to send this to the StellaZ
Please help. Please remember that I'm new to Z-wave and not an expert
/Nils