Need help configuring hold button to dim up/down

[erikst]

I have the Merten CONNECT Z-wave system, 2-gang push buttons and Universal flush-mounted 250 VA dimmer.

When configuring with z-wave, I can't get the push buttons to dim the switches. The push buttons only turn the switches on or off, no dimming.

Does anyone know how to configure this?

Best regards
Erik

[PoltoS]

But in general you have to configure parameter 0 in your device. Have a look in the manual or on http://pepper1.net/zwavedb/device/69.Also note that this device violates Z-Wave standarts and uses parameter number 0. They should start from 1. This can lead to impossibility to configure it with Z-Way/Z-Cloud.

[Mowitz]

I have the exact same problem. Did you find a solution?

According to the link above, parameter 0 is for switching/dimming/shutters. How do I know which value to set for dimming. I assume it's 1, i.e. 0 for switching, 1 for dimming and 2 for shutters? Is that correct?

Thanks!