Problems with EZMotion config/usage.

Discussions about existing Z-Wave device and their usage with Z-Way/Z-Cloud/Z-Box
Post Reply
AtomicGrog
Posts: 4
Joined: 26 Jun 2014 01:27

Problems with EZMotion config/usage.

Post by AtomicGrog »

I have a Express Controls EZMotion sensor, looks like it's registered correctly and I can see that it's sending events when motion is triggered:

[2014-06-27 23:52:04.429] SETDATA devices.11.data.lastReceived = 0 (0x00000000)
[2014-06-27 23:52:04.643] SETDATA devices.11.data.lastReceived = 0 (0x00000000)

However it doesn't seem to have been setup the same as my other sensor (An AeonLabs Binary Sensor) - fair enough it's not the same device, however unlike the Aeon sensor it doesn't have the concept of 'Triggered' or 'Idle', rather it simply has a Generic value of '0' which never changes.

Any thoughts? to me it looks like the way that z-wave is using the device is wrong, it's not a value based outcome, it's more based on a triggered even with an eventual timeout.

TIA.

Atomic.
Post Reply