Linear GD00Z-X Garage Door Opener

Discussions about existing Z-Wave device and their usage with Z-Way/Z-Cloud/Z-Box
zhack
Posts: 2
Joined: 08 Feb 2016 22:24

Re: Linear GD00Z-X Garage Door Opener

Post by zhack »

Sorry for resurrecting an old thread, but I recent installed a GD00Z-4 and added it to my ZWay network. I can't seem to get it to register the BarrierOperator command class. I have tried excluding and including, but the interview always seems to get stuck and never shows BarrierOperator as a command class. Based on this thread, it seems I should at least be able to issue http commands, but without BarrierOperater, that would seem impossible. I'm new to the inner workings of ZWay. So I am not too sure where to look for potential errors.

Anyone have any ideas? I've attached some screenshots of what I am seeing. Thanks in advance.

System Info:
System Info
System Info
Screen Shot 2016-02-08 at 1.28.15 PM.png (106.29 KiB) Viewed 4564 times
Interview:
Interview
Interview
Screen Shot 2016-02-08 at 1.25.28 PM.png (382.59 KiB) Viewed 4564 times
Interview Results:
Interview Results
Interview Results
Screen Shot 2016-02-08 at 1.25.13 PM.png (94.72 KiB) Viewed 4564 times
zhack
Posts: 2
Joined: 08 Feb 2016 22:24

Re: Linear GD00Z-X Garage Door Opener

Post by zhack »

Ok. So I was using my Razberry as a secondary controller and the primary controller seems to the the culprit. I changed the Razberry to the main controller, re-included and now I have all the command classes.
Post Reply