According to the log, it seems to me that it has been removed. Look at the last few lines where your device reports back it's current associatoins for Group 2:
I bought some Qubino Switch Inserts and had no problems to operate them in Z-Way (2.2.1-rc and I run them from Smarthome UI only) but I faced a problem even worse. While playing with the switches I got an electric shock. I found that the two little pins - or at least one of them - that are supposed to connect external sensor have life wire.
I wonder why these devices are still sold without even putting some label over the pins. Even if I take care not to touch the stuff who will know this after some time when by successor opens the wall box. So be cautious not touching the devices when power is on.
Reports have different release dates, but in a quick scan I noticed the same FAILED safety tests.
It is a pity that Qubino does not want to repond on this forum to explain the situation. In case these are false reports, there is even more reason to respond....
I am facing issues with qubino flush dimmer. To be honest I was not able to get this stuff being included properly.
Just after inclusion Qubino zwave reports device is dead. Sometimes zwave is able to get some interview informations sametimes not. But always Qubino goes into "dead" state just after few seconds after inclusion.
When I am trying to reqest NIF from qubino nore I see that I am receiving something, but it looks like zwave is ignoring it?