Has anyone had success setting up an Ecolink Garage Door Sensor? Specifically the TILT-ZWAVE2.5-ECO-2
I just bough two brand new ones from Amazon and they will not go past 92% on the interview process when trying to include them via the zwave razberry page. After a bit it will ask to cancel. If I cancel, I do see the device on the zwave device page (and they appear to work), but the interview for the SensorBinary shows incomplete. It also will not show up in homebridge (even after restart and even a reboot of rpi). Tried many times to exclude and then include again- all same results. Suggestions?
Discussions about existing Z-Wave device and their usage with Z-Way/Z-Cloud/Z-Box
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests