Qubino - temperature sensor
Posted: 17 Apr 2017 18:06
Im having problems with the temperature sensor on Qubino Flush Shutter DC (http://qubino.com/products/flush-shutter-dc/).
To be able to include the device at all I need to use the expert UI, and to do "force interview". After that everything seems to be OK, but the temperature is not updating. It does seem to recognise the sensor correctly. The interview result for the SensorMultiLevel looks like this:
/: None (04:44 AM)
1: None (04:45 AM)
sensorTypeString: Temperature (04:44 AM)
val: 35.5 (04:45 AM)
deviceScale: 0 (04:45 AM)
scale: 0 (04:44 AM)
scaleString: °C (04:45 AM)
supported: true (04:44 AM)
version: 7 (04:44 AM)
security: false (04:44 AM)
interviewDone: true (04:45 AM)
interviewCounter: 9 (04:44 AM)
typemask: 1 (04:44 AM)
It even seem to read the value correctly. It reads a correct value every time I do the interview. Here I was holding the sensor in my hand while doing the interview, and the value is 35.5C.
After the interview however, the temperature stays put at 35.5C. There is some parameter settings, like #120=5 saying it should report every 0.5C. Im getting no error messages at all.
Any ideas?
To be able to include the device at all I need to use the expert UI, and to do "force interview". After that everything seems to be OK, but the temperature is not updating. It does seem to recognise the sensor correctly. The interview result for the SensorMultiLevel looks like this:
/: None (04:44 AM)
1: None (04:45 AM)
sensorTypeString: Temperature (04:44 AM)
val: 35.5 (04:45 AM)
deviceScale: 0 (04:45 AM)
scale: 0 (04:44 AM)
scaleString: °C (04:45 AM)
supported: true (04:44 AM)
version: 7 (04:44 AM)
security: false (04:44 AM)
interviewDone: true (04:45 AM)
interviewCounter: 9 (04:44 AM)
typemask: 1 (04:44 AM)
It even seem to read the value correctly. It reads a correct value every time I do the interview. Here I was holding the sensor in my hand while doing the interview, and the value is 35.5C.
After the interview however, the temperature stays put at 35.5C. There is some parameter settings, like #120=5 saying it should report every 0.5C. Im getting no error messages at all.
Any ideas?