Remotec ZTS-500US Thermostat won't complete interview
Posted: 27 Oct 2017 01:36
I've tried excluding and including the thermostat several times. Almost the whole interview completes except for "ThermostatOperatingState" The statemask can never seem to update. It seems like State 0 is off, state 1 is heat, and state 2 is cooling.
Is user error involved? Is this a Z-wave.me issue, or is this an issue with the thermostat?
I'm trying to control a fan connected to a z-wave power switch, based on the thermostats operating state. When the thermostat is calling for heat, i'd like the fan to come on after a set delay. When the thermostat stops calling for heat, I'd like the fan to shut off after a set delay as well.
Association group 2 in the thermostat can turn the fan on and off, but I can't figure out how to delay startup or shutdown of a switch with that association group, and that doesn't solve the interview issue either...
Any help is much appreciated.
Is user error involved? Is this a Z-wave.me issue, or is this an issue with the thermostat?
I'm trying to control a fan connected to a z-wave power switch, based on the thermostats operating state. When the thermostat is calling for heat, i'd like the fan to come on after a set delay. When the thermostat stops calling for heat, I'd like the fan to shut off after a set delay as well.
Association group 2 in the thermostat can turn the fan on and off, but I can't figure out how to delay startup or shutdown of a switch with that association group, and that doesn't solve the interview issue either...
Any help is much appreciated.