both relays works from the interface.
but only sw1 update the GUI after a manual change.( sw2 don't update the GUI).
in the device manual I found the reason :
"For Wall SW1, ZL 7432 will report the status of On/OFF after doing “Association”.
However, Wall SW2 will only report the status if Z-Wave™ Interface Controller
support Multi Channel command, and send Get Command to ask ZL 7432 Wall SW
2 to report the status."
but I don't know how can achieve this.
thank you in advanced for your help
VISION In-Wall Dual Relay Switch ZL7432 status update problem
Re: VISION In-Wall Dual Relay Switch ZL7432 status update problem
is somebody is interested I found the workaround:
basically when s2 is switched manually. the device send the status of the s1 to the controller. at that point you must update s2 getting the status update
basically when s2 is switched manually. the device send the status of the s1 to the controller. at that point you must update s2 getting the status update