Note:The intention of this topic is to become a FAQ about (binary) Switches. Suggestions for other tested problem/solution are welcome
Question:Binary Switch does not send unsolicited status updates. Answer: Using a WEBbrowser send the following command. nodeid is the number of the Z-wave device.
I did not intend to suggest it had to do with versions. It was just to say that when I originally installed them that all five Z-Wave.Me Switches were functioning properly.
There are two remaining that are still wrong after several attempts. Would it help to disconnect them from the 230V for a couple of minutes? I remember having seen that somewhere, but don't remember if it was this one.