Z-Way v4.0.0-102-g45c41aa6
Razbery 7 Pro 7.28
I have sketch with 10 switches, S2 security. I've tried getter/setter and also dynamic style. I have reuploaded sketch/excluded-included Z-Uno few times, between tests.
If i send all 10 commands at once i.e. via scene at some point I get this info in job queue
Later there is alsoResponse received - transfered to encapsulated jobs
Callback received - transfered to encapsulated jobs
Delivered
Security S2 resynchronization. Retrying
and finallySecurity S2 Nonce Report Delivered
But some switches are not triggered - Z-Way correctly show on dashboard that some switches were not triggered, the same can be spoted via serial monitor on Z-Uno side - some variables are not updated. I can of course send those 10 command with 500ms delay from each other, i.e. via automation module and everything works correctly but I'm not satisfied with this.SwitchBinary Set Delivered
Is there any way to send those 10 commands via single packet? As for now I've created 11th channel, an RGB and I can encode those 10 switches state as bits in RGB, so I can trigger them with single packet - but this is silly.
Sending this via config parameters is not feasible as those are automaticlly saved to EEPROM and I can't prevent it. EEPROM would wear out quickly.
Maybe some other ideas? Thank you.
btw: z-uno 2 is awesame