Hi
I am having inclusion problem with Vera.
First I got it included and it was added as a dimmer in my z-wave network.
Then I tried to upload a new sketch and I got a message that the z-uno was not detected anymore. Tried to unpair/exclude it but it could not get any connection to it so I in the end deleted it from my Vera. I then reset the z-uno and I tried to add it again. No reaction from my Vera. Then I tried the factory reset, still did not work. Then I tried recover and also factory reset, still no response.
I don't know what to do now so I wondered if you could give me any ideas. Have tried going back to backup on Vera from before I got the z-uno to get a fresh z-wave network but that did not work either.. I am lost!!!
-Stian
Help! Pairing mode not working any more...
Re: Help! Pairing mode not working any more...
Please try rescue mode and factory reset. http://z-uno.z-wave.me/getting-started/ ... SerialPort
Also make sure the frequency of your Z-Uno is same as of Vera
Also make sure the frequency of your Z-Uno is same as of Vera