Digital Output Pins 19-22

Discussion about Z-Uno product. Visit http://z-uno.z-wave.me for more details.
Post Reply
joergm6
Posts: 24
Joined: 03 Nov 2016 21:16

Digital Output Pins 19-22

Post by joergm6 »

Hello
I use 4 switches on pins 9-12 (digital-out). Everything works wonderful.
If I only change pins 9-12 to 19-22, everything else remains unchanged, then the outputs switch only shortly for a fraction of a second (LED flashes shortly).
Currently I need only 4 pins, but wanted to ask. :D
thank you
A.Harrenberg
Posts: 201
Joined: 05 Sep 2016 22:27

Re: Digital Output Pins 19-22

Post by A.Harrenberg »

Hi,

I found that the pins 19 to 22 are going to LOW state when a ZWave transmission is active, so zunoSendReport() from the sensor or a command from the controller to the Z-Uno.

I expect that this is what you experience here as well.

It was reported and the team is currently looking for the root cause of this. So for now I would recommend to not use the pins 19 to 22 at all.

Regards,
Andreas.
fhem.de - ZWave development support
joergm6
Posts: 24
Joined: 03 Nov 2016 21:16

Re: Digital Output Pins 19-22

Post by joergm6 »

Thanks for the information. I had started with these pins to try and after a few hours ... I doubted myself :roll: :mrgreen: . But 9-12 is working and that is enough for me at the moment.
regards
RobertHerter
Posts: 2
Joined: 24 Dec 2016 11:26

Re: Digital Output Pins 19-22

Post by RobertHerter »

Any News here ?.

for my Controller i need 8 Digital Outs. 19-22 are unusable, because of switching on z-wave transmit.

Regards

Robert
michap
Posts: 437
Joined: 26 Mar 2013 10:35
Contact:

Re: Digital Output Pins 19-22

Post by michap »

RobertHerter wrote:for my Controller i need 8 Digital Outs.
you can use Pin 9-16

Michael
User avatar
PoltoS
Posts: 7565
Joined: 26 Jan 2011 19:36

Re: Digital Output Pins 19-22

Post by PoltoS »

You can also use pins 0-8. We will focus on this in next release after NY.
Rogga10000
Posts: 10
Joined: 13 Nov 2016 21:05

Re: Digital Output Pins 19-22

Post by Rogga10000 »

Bad news for me. Planning control a relay from Pin 17 to make it work on the circuit board layout.

I did not manage to read analog values ​​from input A2 and A3 to my Fibaro. My code is based on the 10 channel example.

I will patiently wait for the next version and hope you manage to bring order to these basic bugs :(
User avatar
PoltoS
Posts: 7565
Joined: 26 Jan 2011 19:36

Re: Digital Output Pins 19-22

Post by PoltoS »

Problem found. We will fix it in 2.0.8
Post Reply