Sketch not uploading

Discussion about Z-Uno product. Visit http://z-uno.z-wave.me for more details.
Post Reply
Black Cat
Posts: 62
Joined: 02 Mar 2016 00:52

Sketch not uploading

Post by Black Cat »

I have a sketch uploaded on ZUNO, however if I try to over write this with another different sketch, the original remains.

The upload doesn't indicate failure however the new sketch is not uploaded. Something is preventing overwriting.
How can I erase the sketch that is in ZUNO and upload a new sketch.
User avatar
PoltoS
Posts: 7565
Joined: 26 Jan 2011 19:36

Re: Sketch not uploading

Post by PoltoS »

Sketch will not be applied if it changes the types of channels in an included Z-Uno. To exclude and include it again to be applied. This is a requirement by the Z-Wave protocol
Black Cat
Posts: 62
Joined: 02 Mar 2016 00:52

Re: Sketch not uploading

Post by Black Cat »

I found that a Factory reset eventually worked. Still took a long time, the Z-UNO instructions on Factory reset and Rescue Mode don't seem to be very clear in this respect.
Post Reply